Error code F23 - after changing out thermal cut-off and inlet thermistor/high limit ran a load on normal and clothes were dry and unit shut off about 1/2 way through the cycle leaving an error code F23. Reading your Q&A by Nick and MasterTech on their Jul29 blog it says to check the red wire terminal at the cut off to the red wire terminal at the heater. > If the resistance is about 10 ohm go to step 5. Which leads to my question on the next steps. Going to step 5 where do I find or how do I identify the P4-3 (red wire) and P4-6 (red wire) and the connector