Questions And Answers

I have whirlpool front load washer with a code F25. I am not an expert at repairing washers bUt I am handy. I tried unplugging and plugging the washer. .

Question: I have whirlpool front load washer with a code F25. I am not an expert at repairing washers bUt I am handy. I tried unplugging and plugging the washer. .

MOD: WFW9750WW01 Ser: CSY4908292

F25 means that your main central control board (CCU) and the motor control board (MCU) are not communicating with one another properly.

The motor control board is located under the tub mounted to the floor of the washer.

The CCU is mounted under the top panel of the washer and is the part with about 100 wires going into it. The first thing you'll want to do is remove the top panel and the lower front panel to look and make sure the belt is connected on the back of the washer and check the wire connections and make sure they are all secure.
If everything looks good, then you just have to guess which control board you want to replace first, either the MCU or the CCU and the problem is that there is no way to test and determine which part is faulty so it's just a guessing game. That being said, I find that the MCU causes this issue more than the CCU so I replace that first.

The MCU and CCU part information for model  WFW9750WW01 is linked below:

Click here for Central Control Unit | CCU Information

Click here for Motor Control Unit | CCU Information


View Page This Question Was Posted On