Questions And Answers

f28 error code on whirlpool washer

Question: f28 error code on whirlpool washer

Washer runs fine after couple loads goes to f28 error reset and runs then same problem could be motor control board?

Unplug all the connections from the motor control board to the central control unit and plug them back in. It may just be a loose connection that is losing contact when the washer moves around a bit. If that does not solve the problem, then replace the motor control unit if the problem persists after that replace the central control unit as there is no way to tell which board is causing the problem. Under warranty, we just replaced both boards. In your case I would recommend if, after checking the wiring connections, you still have issues replace both boards with used boards. You can get the used ones pretty cheap compared to new ones, and considering the age of your washer. You don't want to spend the money on two new boards. You can get the boards used at the link below if you are not sure what part numbers you need just ask them in chat. 

https://prismparts.com/


View Page This Question Was Posted On