Appliance Overview
Brand: Frigidaire
Model Number: GLTF2940FS
Appliance Type: Washer

Appliance Type: Front Load Washer
Model: GLTF2940FS

Common Issue: - Washer stops after the wash cycle and does not spin and drain.

Repair Advice:

If your Frigidaire Front Load Model GLTF2940FS washer stops after the wash cycle and does not spin and drain, follow these troubleshooting steps:

1. Check the pump clean-out to ensure it's not obstructed.

Cleaning the Tub-to-Pump Hose on Frigidaire Front Load Model GLTF2940FS

Over time, the tub-to-pump hose on your Frigidaire Front Load Washer (Model GLTF2940FS) can become clogged with debris, affecting the washer's performance. Regular cleaning of this hose is essential for maintaining the efficiency of your machine. Here's how to do it:

1. Unplug the Washer: Safety first. Always unplug the appliance from the power outlet before performing any maintenance.
2. Access the Hose: The tub-to-pump hose is located at the bottom of the washer. You will need to remove the back panel or the front lower access panel to reach the hose.
3. Prepare for Water Drainage: Have a bucket or towels ready, as water may still be in the hose.
4. Remove the Hose: Loosen the clamps that secure the hose to the tub and the pump. Carefully remove the hose and be prepared for any residual water spillage.
5. Inspect and Clean the Hose: Check the hose for any obstructions or debris. Flush the hose with water or use a long brush to clean the inside thoroughly.
6. Reattach the Hose: Once cleaned, reattach the hose to the tub and the pump. Ensure the clamps are secure to prevent any leaks.
7. Test the Washer: Plug the washer back in and run a short cycle to ensure everything is working correctly and there are no leaks.

If you did not find any obstructions in the hose and the washer still won't drain after performing the steps above, replace the drain pump.